Mirtone QuickStart Front Panel Programming Getting Started Guide 19
Next, enter the basic system parameters. These can be left at their default values unless
your project requires customizations.
To enter system parameters:
1. From the Configure menu, choose System > ALM/RST Inhib.
2. From the Alarm/Reset Inhi screen choose the desired value. This sets the time for
which these operations are inhibited after an alarm has occurred.
3. Choose AC Power Dly then choose the desired value. This sets the time delay for
sending a trouble message after an AC power loss.
4. Choose Exit then Save Edits.
This returns you to the Configure menu.
To Next Page
Loading...