Mirtone QuickStart Front Panel Programming Getting Started Guide 17
10. From the Update Database menu, choose Save and Sync. (Again, choose Save if your
project does not have remote annunciators).
After the AutoLoop process is complete and the database has been saved, the system goes
through its reboot process. After the reboot, a “System Normal” message is displayed on
the LCD. The panel is now fully functional with default general alarm system
programming.
Caution: Perform the AutoLoop only once per SLIC card when you are configuring a
new system, or when you are adding a SLIC card. Performing an AutoLoop on a SLIC
after it has been programmed erases all the device programming information.
To Next Page
Loading...