Mirtone QuickStart - Page 29

Mirtone QuickStart Front Panel Programming Getting Started Guide 29
3. If you’re editing an existing output group, select the output group from the list, then
press Enter on the panel to continue to the Output Group menu.
4. Choose Responses > Active > Add > Dialer, then choose the account.
5. From the Response Dialer menu, choose Send On.
6. From the Response Send On menu, choose Activation.
7. From the Response Dialer menu, choose Priority.
8. From the Priority menu, choose Life Safety (Life Safety is used for any alarm input
device).
9. From the Response Dialer menu, choose String, enter the dialer string, then press
Enter on the panel.
Refer to the topic “Dialer configuration - dialer strings” for string values.
10. Repeat steps 5 through 9, except under Response Send On choose Restoration, then
enter the restoration dialer string.
11. From the Response Dialer menu, choose Exit, then Save Edits.
12. From the Output Group menu choose, Exit, then Save Edits.
13. Repeat steps 1 through 12 for each dialer string required.