Mirtone QuickStart - Page 31

Mirtone QuickStart Front Panel Programming Getting Started Guide 31
7. Press Menu on the panel to return to the Zone Edit menu, then choose Output Group.
8. From the Output Group menu, choose Add.
The system displays a list of the output groups you’ve created. Select the output
group to which this zone is being correlated, then press Enter on the panel. This
returns you to the Output Group menu.
9. Press Menu on the panel.
This returns you to the Zone Edit menu.
10. From the Zone Edit menu, choose Exit then Save Edits.
This returns you to the Configure menu.
11. For each zone that needs to be created, repeat steps 1 through 10.
12. When all zones have been created, from the Configure menu choose Exit, then Save
and Sync.
The panel goes through its reboot process.