Mitsubishi Electric FR-F740-00023

259
Setting from the parameter unit, operation panel
4
/:D:O$>$D+
J!K H=*1L#(,&#=&((*1L#;*<%#%*.&#<#?-(&1(*-B&(&)#(-#=&(#(,&#@)&Z7&1'8"
U85+#0.($&5@#?875 S"#$/.$/&0"5&*+5K)5$,'&*+(?&>kV&0(&^>kV&9)+.$/&(85+#0.($
D$O:Db+
 3*&0"5&9.-87#'&,"#$/5-&*+(?&*7.,%5+.$/&O^>6>>O&0(&O>6>>OB&0"5&-500.$/&(*&Pr. 161 Frequency setting/key lock operation selection&?#'&$(0
25&OFO6
 3$9585$95$07'&(*&C"50"5+&0"5&.$45+05+&.-&+)$$.$/&(+&#0&#&-0(8B&0"5&*+5K)5$,'&,#$&25&-50&2'&?5+57'&0)+$.$/&0"5&9.#76&
 P"5$&0"5&*+5K)5$,'&.-&,"#$/59B&.0&C.77&25&-0(+59&.$&WWd;U1&#-&0"5&-50&*+5K)5$,'&#*05+&F>-6
G:H>5IE
 P"5$&)-.$/&-500.$/&9.#7B&0"5&*+5K)5$,'&/(5-&)8&0(&0"5&-50&4#7)5&(*&Pr.1 Maximum frequency&[.$.0.#7&4#7)5&gF]>kV&[>FFE>&(+&75--\&Y
E>kV&[>FG>>&(+&?(+5&\6
DisplayOperation
PU indication is lit.
Flicker ··· Parameter setting complete!!
7. Press to set.
The parameter number
previously read appears.
1. Screen at powering on
The monitor display appears.
2. Press to choose the PU operation
mode.
3. Press to choose the parameter
setting mode.
11.
Turn until " " appears.
The flickering frequency is the set frequency.
You need not press .
The frequency flickers for about 5s.
Flicker ··· Parameter setting complete!!
8. Change Pr. 161 to the setting value of " "
in the similar manner.
(Refer to step 4 to 7.)
9. Mode/monitor check
Press twice to choose
monitor/frequency monitor.
10. Press (or ) to start the inverter.
4. Turn until (Pr. 160) appears.
5. Press to read the present set value.
" " (initial value) appears.
6. Turn to change it to
the setting value " ".