Mitsubishi Electric FR-F740-00023

261
Parameter clear
4
/:D:O$>$D+
4.23 Parameter clear
/I5E>
tb50&OFO&.$&Pr. CL parameter&clear&0(&.$.0.#7.V5&8#+#?505+-6&[d#+#?505+-&#+5&$(0&,75#+59&C"5$&OFO&.-&-50&.$&Pr. 77
Parameter write selection6&3$&#99.0.($B&,#7.2+#0.($&8#+#?505+-&#+5&$(0&,75#+596\
+&((*1L R&=')*?(*-1
> Q(0&5@5,)0596
F
;50)+$-&#77&8#+#?505+-&0(&0"5&.$.0.#7&4#7)5-&5@,580&*(+&calibration parameters, terminal function selection
parameters, etc6
;5*5+&0(&0"5&7.-0&(*&8#+#?505+-&($&page 322&*(+&#4#.7#2.7.0'&(*&8#+#?505+&,75#+6
&#$9& &#+5&9.-87#'59&#705+$#057'&666&P"'|
!"5&.$45+05+&.-&$(0&.$&0"5&dT&(85+#0.($&?(956&
F6 d+5--& 6
&.-&7.0&#$9&0"5&?($.0(+&[`&9./.0&ZWN\&9.-87#'-&O>O&[Pr. 79&c&O>O&[.$.0.#7&4#7)5\\6
]6 S#++'&()0&(85+#0.($&*+(?&-058&E&#/#.$6&
1. Screen at powering on
The monitor display appears.
Display
Operation
3. Press to choose the parameter
setting mode.
Flicker ··· Parameter setting complete!!
7. Press to set.
5. Press to read the present set value.
" "(initial value) appears.
PU indication is lit.
2. Press to choose the PU operation
mode.
· Turn to read another parameter.
· Press twice to show the next parameter.
· Press to show the setting again.
4. Turn until " " (parameter clear)
appears.
6. Turn to change it to
the setting value " ".
The parameter
number read
previously appears.