Mitsubishi Electric FR-F740-00023

263
Parameter copy and parameter verification
4
/:D:O$>$D+
4.25 Parameter copy and parameter verification
4.25.1 Parameter copy
/G/k#+&((*1L R&=')*?(*-1
>S#$,57
FS(8'&0"5&-()+,5&8#+#?505+-&0(&0"5&(85+#0.($&8#$576
]P+.05&0"5&8#+#?505+-&,(8.59&0(&0"5&(85+#0.($&8#$57&.$0(&0"5&95-0.$#0.($&.$45+05+6
_ a5+.*'&8#+#?505+-&.$&0"5&.$45+05+&#$9&(85+#0.($&8#$576&(Refer to page 264.)
d#+#?505+&-500.$/-&,#$&25&,(8.59&0(&?)70.875&.$45+05+-6
D$O:Db+
t P"5$& 0"5& ,(8'& 95-0.$#0.($& .$45+05+& .-& $(0& 0"5& :;<:=>>& -5+.5-& (+&8#+#?505+&,(8'&C+.05&.-&85+*(+?59&#*05+&8#+#?505+&,(8'&+5#9&.-
-0(8859B&O?(957&5++(+&[ \O&.-&9.-87#'596
t;5*5+&0(&0"5&8#+#?505+&7.-0&($&
page 322&#$9&7#05+&*(+&#4#.7#2.7.0'&(*&8#+#?505+&,(8'6
tP"5$&0"5&8(C5+&.-&0)+$59&(**&(+&#$&(85+#0.($&8#$57&.-&9.-,($$5,059B&50,6&9)+.$/&8#+#?505+&,(8'&C+.05B&85+*(+?&C+.05&#/#.$&(+&,"5,%&0"5
4#7)5-&2'&8#+#?505+&45+.*.,#0.($6
1.Connect the operation panel to the
copy source inverter.
• Connect it during a stop.
Display
Operation
2.Press to choose the parameter
setting mode.
Flicker ··· Parameter copy complete!!
6.Press to copy the source parameters
to the operation panel.
4.Press to to read the present set value.
" "(initial value) appears.
Flicker ··· Parameter copy complete!!
9.Press to write the parameters copied to
the operation panel to the destination inverter.
3.Turn until (parameter copy)
appears.
5.Turn to change it to
the setting value " ".
The frequency flickers
for about 30s
The frequency flickers
for about 30s
About 30s later
10.When copy is completed,
" " and " " flicker.
11.After writing the parameter values to the copy
destination inverter, always reset the inverter,
e.g. switch power off once, before starting operation.
7.Connect the operation panel to the
copy source inverter.
8.After performing steps 2 to 5,
turn to change it to " ".
The parameter
number previously
read appears.