２ Robot arm
Options 2-30
■ Cable configuration
The configuration of the flexible cable is shown in Table 2-14. Refer to this table when selecting the cable bare.
Table 2-14 ： Cable configuration
Note) The square in the cable name indicates the cable length.
■ Fixing the flexible cable
(1) Connect the connector to the robot arm .
(2) Wind the silicon rubber around the cable at a position 300 to 400 mm from the side of robot arm and exten
-
sion section as shown in Fig. 2-11, and fix with the nylon clamp to protect the cable from external stress.
Fig.2-11 ： Fixing the flexible cable
Item
Motor signal cable
1S- □□ LCBL(S)-01
Motor power cable
1D- □□ LCBL(P)-01
No. of cores
AWG#24(0.2mm
2
)-4P AWG#24(0.2mm
2
)-7P AWG#18(0.75mm
2
) AWG#17(1.25mm
2
)-4C AWG#19(0.75mm
2
)-4C
Finish dimensions Approx. φ6mm Approx. φ8.5mm Approx. φ1.7mm Approx. φ7.5mm Approx. φ6mm
No.of cables used 5 cables 1 cable 1 cable 2 cable 8 cable
No. in total 7 cables 10 cables
Silicon rubber
Nylon clamp
1S-□□LCBL(S)-01
1S-□□LCBL(P)-01
300～400ｍｍ
NK-18N
NK-14N
Controller
300～400ｍｍ
NK-14N
NK-18N
Nylon clamp
Robot arm
The fixed cable
(standard attachment)
Extended flexible cable
(option)
Extension section
Motor signal cable
Motor power cable
Nylon clamp
Nylon clamp
Nylon clamp
CN1
CN2
Controller
(CR2D-700)
Cover the extension terminal area with
the cover etc. so that it may not be
easily touched to the latch lever.
CAUTION
The cable shall bend and size shall be
140mm or more.
CR2DA-700 series
CR3D-700 series
CR2DA-700 series: 5m
CR3D-700 series: 7m
To Next Page
Loading...
