How to fix Mitsubishi Electric Industrial Electrical error H0230?
If the Mitsubishi Electric Industrial Electrical system shows error H0230, it means there's an issue with a safety function parameter setting. To resolve this, check the parameter setting indicated in the error message (xxxxx) and adjust it to an appropriate value.
What to do if Mitsubishi Electric Industrial Electrical shows error H0241?
If you encounter a fault in safety communication (error H0241) with your Mitsubishi Electric Industrial Electrical, first, turn the power OFF and then ON again. If the error persists, this issue can also occur when the machine lock function and controller CPU drive mode are enabled. Try disabling these functions/modes and then cycle the power of the robot controller.
How to resolve CRC errors in Mitsubishi Electric Industrial Electrical safety parameters?
If you are getting a CRC error in the safety parameter of your Mitsubishi Electric Industrial Electrical (error H0231), check the safety parameter settings and write the parameters again.
What should I do if Safety IO and Safety comm are disabled in Mitsubishi Electric Industrial Electrical?
If both Safety IO and Safety communication are disabled on your Mitsubishi Electric Industrial Electrical (error H0250), you must enable either Safety IO or Safety communications to enable the safety function.
How to configure network selection settings for Mitsubishi Electric Industrial Electrical safety communication function?
If the network for the safety communication function is not selected in your Mitsubishi Electric Industrial Electrical (error H0248), you need to configure the network selection settings.
What causes error H0242 in Mitsubishi Electric Industrial Electrical?
If your Mitsubishi Electric Industrial Electrical system detects a fault in safety data (error H0242), turn the power OFF and then ON again.
Why does Mitsubishi Electric Industrial Electrical show error H0249?
If multiple networks have been selected for the safety communication function in your Mitsubishi Electric Industrial Electrical (error H0249), check and correct the network selection settings of the safety parameter.
What to do if Mitsubishi Electric Industrial Electrical safety function is disabled (C0240)?
If the safety function is disabled in your Mitsubishi Electric Industrial Electrical (error C0240), even though the safety logic is configured, you should either delete the safety logic or enable the safety functions.
What to do if Mitsubishi Electric Industrial Electrical safety IO is disabled (C0244)?
If the safety IO logic is set but the safety IO is disabled in your Mitsubishi Electric Industrial Electrical (error C0244), you should either delete the safety IO logic settings or enable safety IO.
What to do if Mitsubishi Electric Industrial Electrical safety communication is disabled (C0245)?
If the safety communication logic is set, but the safety communication function is disabled in your Mitsubishi Electric Industrial Electrical (error C0245), you should either delete the safety communication logic settings or enable safety communication.
General| Model | R56TB |
|---|---|
| Slots | 6 |
| Mounting | DIN rail |
| Operating Temperature | 0 to +55 °C |
| Storage Temperature | -25 to +75 °C |
| Humidity | 5% to 95% (non-condensing) |
To Next Page