81
13.2. Program list
The lists of the program files are displayed.
For programs in the robot controller, the "Name", "Size", "Date", "Time", as well as the "Protect information", "No. of
lines", "No. of position variables", "Latest cycle time", "Average cycle time", "Operation time", "No. of cycles" and
"Comment“ are displayed.
* As for the program files in the USB memory and in the controller, when even the contents are the same, the
program sizes are different.
Select
“USB”, and
tap on the “Browse” but
ton (<a>) and select
folder,
and the folder in the USB
memor
y can
be
shown.
(Note) Program select function of the Program list is available with Ver.2.3 or later of this software.
Release the
selection in the list.
To Next Page
Loading...
