APPENDICES
Appendix 4 Operation Examples of When the Remote Head Module Is Mounted
79
A
• To perform the preset
■Program example of the counter function selection
When using the functions listed below, use the following programs.
• To use the count disable function
• To use the latch counter function
• To use the sampling counter function
• To use the cycle pulse counter function
■Processing of the overflow detection
Create the program only when the linear counter is used.
(126) Turns on 'CH1 Preset command' (Y1001).
(148) Turns off 'CH1 Preset command' (Y1001).
(157) Starts and stops the count disable function
(159) Starts and stops the latch counter function
(157) Starts and stops the latch counter function
(157) Starts and stops the cycle pulse counter function
(178) Turns on 'LED signal for overflow occurrence check' (Y41) when an overflow is detected.
To Next Page
Loading...
