Mitsubishi 3000GT - Brush Replacement (from 1996 Models)

16-18
ENGINE ELECTRICAL - Charging System
Soldered
Limit line
&
m
m
o L%
4
-if
T
9EN0192
(5) Solder pigtail to brush holder as shown in the illustration.
BRUSH REPLACEMENT <From 1996 models>
(1) Replace brush by the following procedures if it has been
worn to limit line.
(2) Unsolder pigtail and remove old brush and spring.
(3) When installing a new brush, push the brush in the brush
holder as shown in the illustration, and solder the lead
wire.
1 TSB Revision