16-46
ENGINE ELECTRICAL
-
Ignition
Svstem
27ELOO95
J
INSTALLATION SERVICE POINTS
.A+CRANKSHAFT
POSITION SENSOR INSTALLATION
<Up
to 1992 model>
(1) Turn the crankshaft so that the No. 1 cylinder is at
compression top dead center.
Caution
Be careful not to turn it to the No.
4
cylinder com-
pression top dead center by mistake.
(2) Install, lining up the matchmarks on the crankshaft
position sensor housing and the coupling.
,B+SPARK
PLUG CABLE INSTALLATION
Improper arrangement of spark plug cables will induce
voltage between the cables, causing miss firing and devel-
oping a surge at acceleration in high-speed operation.
Therefore, be careful to arrange the spark plug cables
properly by the following procedure.
1.
install the spark plug cable clamps as shown in the
illustration.
2.
The numerals on the support and clamp indicate the
spark plug cable No.
3.
Pay attention to the following items when the spark
plug cables are installed.
(1)
Install the cables securely to avoid possible contact
with metal parts.
(2) Install the cables neatly, ensuring they are not
too tight, loose, twisted or kinked.
/
TSB Revision
To Next Page
Loading...
