16-28
ENGINE ELECTRICAL
-
Starting System
Stop ring
Z6EL0097
Z6ELOO96
+B,SNAP
RING
/
STOP RING REMOVAL
(1) Press the stop ring, by using an appropriate socket,
wrench, to the snap ring side.
(2)
After removing the snap ring (by using snap-ring pliers),
remove the stop ring and the overrunning clutch.
STARTER MOTOR PARTS CLEANING
1.
Do not immerse parts in cleaning solvent. Immersing the
yoke and field coil assembly and/or armature will damage
insulation. Wipe these parts with a cloth only.
2.
Do not immerse drive unit in cleaning solvent. Overrunning
clutch is pre-lubricated at the factory and solvent will wash
lubrication from clutch.
3. The drive unit may be cleaned with a brush moistened
with cleaning solvent and wiped dry with a cloth.
REASSEMBLY SERVICE POINT
,A+TOP
RING
/
SNAP RING INSTALLATION
Using a suitable pulling tool, pull overrunning clutch stop
ring over snap ring.
INSPECTION
COMMUTATOR INSPECTION
(1) Place the armature on a pair of V-blocks, and check the
deflection by using a dial gauge.
Standard value: 0.05 mm
(JO20
in.)
Limit: 0.1 mm
(.004
in.)
TSB Revision
To Next Page
Loading...
