EasyManua.ls Logo

Mitsubishi 3000GT - Battery Inspection; Battery Specifications; Starting System

Mitsubishi 3000GT
738 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHASSIS ELECTRICAL
-
Battery
54-3
BATTERY
L
SPECIFICATIONS
GENERAL SPECIFICATIONS
Items
Up to
1993
models
From
1994
models
Type
75D26R-MF 75D23R-MF
Ampere hours
(5HR)
Ah
52 52
Cranking rating [at
-18°C
(O’F)] A
490
520
Reserve capacity min.
123
118
NOTES
1.
CRANKING RATING
is the current a battery can deliver for 30 seconds and maintain a terminal voltage of
7.2
volts or greater at a specified temperature.
2. RESERVE CAPACITY RATING
is the amount of time a battery can deliver 25A and maintain a minimum terminal
voltage of 10.5 at
27%
(80°F).
L
16FO123
White
Blue
Charging
Good
necessary
condition
ON-VEHICLE
SERVICE
BATTERY INSPECTION
BAlTERY
VISUAL CHECK (1)
The battery contains a visual test indicator which gives blue
signal when an adequate charge level exists, and white signal
when charging is required.
BAlTERY
VISUAL CHECK (2)
Make sure ignition switch is in Off position and all battery
feed accessories are Off.
1.
Disconnect ground cable from battery before disconnecting
(+)
cable.
2. Remove battery from vehicle.
Caution
Care should be taken in the event battery case is
cracked or leaking to protect hands from the electro-
lyte. A suitable pair of rubber gloves (not the house-
hold type) should be worn when removing battery
by hand.
3.
Inspect battery carrier for damage caused by loss of acid
from battery. If acid damage is present, it will be necessary
to clean area with a solution of clean warm water and
baking soda. Scrub area with a stiff bristle brush and wipe
off with a cloth moistened with ammonia or baking soda
in water.
TSB Revision

Table of Contents

Other manuals for Mitsubishi 3000GT

Related product manuals