CHASSIS ELECTRICAL
-
Lighting System
Up
to 1993 models
From 1994
mod&
__
_..--.
Vertical center line
Z16FO509
J
Hot
z&ky
M-j
’
Within
~ Within
600mm
1
mm (in.)
600 mm
(23.6)
(23.6)
Note
l
’ Up to 1993 models
l
2 From 1994 models
1
Etomj
00002366
00002387
LUMINOUS INTENSITY MEASUREMENT
Measure the luminous intensity of headlights with a photo-me-
ter in accordance with the instruction manual prepared by
the manufacturer of the photometer and make sure that the
luminous intensity is within the following limit.
Limit: 20,000 cd or more
NOTE
(1) When measuring the luminous intensity of headlight, keep
the engine at 2,000 rpm and have the battery charged.
(2) If there are specific regulations for luminous intensity of
headlights in the region where the vehicle is operated,
make sure that the intensity conforms to the requirements
of such regulations.
FOG LIGHT AIMING
1.
Place vehicle on a known level floor 7.6 m (25 feet) from
aiming screen or light colored wall.
2. Use adjusting screw to adjust the top end of high intensity
zone to dimension A.
BULB REPLACEMENT
1.
Disconnect the connector.
2. Turn the bulb socket counterclockwise to pull it out.
Caution
Do not touch the surface of the headlight bulb with hands
or dirty gloves. If the surface dies become dirty, clean
it with alcohol or thinner, and let it dry thoroughly before
installing.
TSB Revision
To Next Page
Loading...
