54-30
CHASSIS ELECTRICAL
-
Meters and Gauges
OIL PRESSURE GAUGE SIMPLE CHECK
Remove the oil pressure gauge unit
coupling connector.
Connect the harness connector via a
test light to the ground.
-1
Place the ignition switch in the ON
posi-
Check the test light and gauge conditions.
(1) Test light lights. (Pointer of gauge does not swing.)
k-1
Replace oil pressure gauge.
1
(2) Test light lights. (Pointer of gauge swings.)
k-1
Replace oil pressure gauge unit.
1
(2) Test light does not light. (Pointer of gauge does not swing.)
/
-1
Correct harness.
VOLTAGE GAUGE SIMPLE CHECK
Check voltage gauge for conditions.
(1) Voltage indicated by voltmeter differs from voltage indicated by
voltage gauge (position indicated by pointer).
-1
Replace gauge.
(2) Gauge does not operate.
/--I
Correct harness or replace gauge.
1
TSB Revision
To Next Page
Loading...
