54-156
CHASSIS ELECTRICAL
-
Radio and Tape Player
RADIO AND TAPE PLAYER WITH ANTI-THEFT SYSTEM
l
When power supply is reconnected after set has been removed from vehicle (after BATT line of set
has been disconnected for more than one hour), what can be effectively performed is only supply
of power made by POWER button operation. (If power supply is connected within an hour, operating
state before disconnection of power supply is resumed.)
IGN
key of vehicle is in ACC position and set is in no display
state.
No display
Abnormal segment op-
*[Faulty
t
Is it possible to set identifi
No
m-Faulty
Yes
Is a beep heard and then does radio operate when PROG button
is placed to ON position after setting four-digit identification number
Is a beep heard and “1 Err” displayed for two seconds before
No
displaying “code”?
c
Faulty set
No
t
Check if identification number on card is input and set correctly.
Is a beep heard and then does radio operate when PROG button
is placed to ON position after setting four-digit identification number
on card aaain?
Yes
-----+
NomxJ
(Error made in input during first setting)
I
No
Is a beep heard and “2 Err” displayed for two seconds before
displaying “code”?
Faulty set
Yes
Press POWER button to erase “code” (to change to no display
state).
I
Yes
Continued to next page.
TSB Revision
To Next Page
Loading...
