Adding and deleting channels
Either "In memory" or
"Not in memory" will
appear.
After all available channels have been programmed automatically,
channels with weaker signals can be adde.d or deleted by using the
following procedure.
First Time Set-Up
Set the clock
Memorize channels
_" Add/delete channels
Set A/V Network
Use ADJUST to select.
Then press ENTER.
Press MENU to return to
TV Main Menu.
lid Press tile MENU button on the
remote control. The TV :Main
Men_: will appear on the screen.
Select "First Time S,_t-Up using
an adjust button; then press the
ENTEP_ button.
Select "Add/delete channels"
using: an adjust button; then
press the ENTER button.
Add/delete channels
Antenna Ant-A
Channel 006
in memory
Use ADJUST to selecl
another channel.
Press CANCEL to delete.
Press MENU to return 'to
First Time Set-Up Menu.
The "Add/delete channels" screen
will appear.
Select the channel you would like
to add or delete using an adjust
button; then press t:he ENTER or
CANCEL button. Channels that
are in memory are labeled, "In
memory"; channels not in
memory are labeled, "Not in
mereory."
Press ENTER to add a channel to
memory. Press CANCEL to
remow_' a channel from memory.
[:>Important:
Only in this menu screen, the CHANNEL • button changes to a
channel with a higher number one by one; the CHANNEL • button
changes to a channel with a lower number one by one.
You may switch between the antennas (Dmtenna A and Antenna B)
by pressing the input button (INPUT).
Getting Started 61
To Next Page
Loading...
Need help?
General
