Mitsubishi Ecodan PAR-WT50R-E - Preparation Before Using the Remote Controller; Battery Installation and Precautions; Installation Options: Bracket and Stand

5
Before Operation
4
GB
Removethebatterycasecoverbeforeplac-
ingthewirelessremotecontroller,andplace
twoAAalkalinebatteriesproperly.
*When the wireless remote controller is not
paired, ithastogothroughapairingprocess.
Fordetailsaboutpairing,contactyourservice
contractor.
■
Batteries
●When isshownonthedisplay,the
batteriesarerunningout.Replacebothof
themwithtwonewAAalkalinebatteries.
●DonotuseNi-Cdrechargeablebatteries.
●TheAAalkalinebatteriesusedonthe
wirelessremotecontrollerlastforabout1
yearundernormalusage.
●Whennotusingthewirelessremote
controllerforlongperiodsoftime,have
thebatteriesremoved.
Caution
Always place batteries with correct po-
larities as indicated in the battery case.
■
Installation
Thewirelessremotecontrollerhastwometh-
odsofinstallation,usinganincludedbracket
orstand.
<< Using a bracket >>
 Determinethepositiontoinstallthewire-
lessremotecontroller.
 Fixthebracketwithflatheadscrews.
 Mountthewirelessremotecontrolleronto
thebracket.
Note)
●Avoidover-tighteningthescrews,whichmaybreakordeformthebracket.
●Toenhancestability,useallthefourscrewstosecurethebracket.