Mitsubishi FR-E520-0.1KN

PARAMETERS
128
<Setting>
Refer to the following tables and set the parameter as required.
Stall Prevention
Operation Voltage
!
: Activated
"
:
Not activated
Stall Prevention
Operation Voltage
!
: Activated
"
:
Not activated
Pr. 156
Setting
Fast-Response
Current Limit
!
: Activated
"
:
Not activated
Acceleration
Constant
speed
Deceleration
OL
Signal
Output
!
:
Operation
continued
"
:
Operation
not
continued
(Note 1)
Pr. 156
Setting
Fast-Response
Current Limit
!
: Activated
"
:
Not activated
Acceleration
Constant
speed
Deceleration
OL
Signal
Output
!
:
Operation
continued
"
:
Operation
not
continued
(Note 1)
0
! !!! !
16
!!!!
"
1
"
!!! !
17
"
!!!
"
2
!
"
!! !
18
!
"
!!
"
3
""
!! !
19
""
!!
"
4
!!
"
!!
20
!!
"
!
"
5
"
!
"
!!
21
"
!
"
!
"
6
!
""
!!
22
!
""
!
"
7
"""
!!
23
"""
!
"
8
!!!
"
!
24
!!!
""
9
"
!!
"
!
25
"
!!
""
10
!
"
!
"
!
26
!
"
!
""
11
""
!
"
!
27
""
!
""
12
!!
""
!
28
!!
"" "
13
"
!
""
!
29
"
!
"" "
14
!
"""
!
30
!
""" "
15
" """
!
31
"""""
Driving
!!!!!
100
Regenerative
""""
!
Note 1: When "Operation not continued for OL signal output" is selected, the
"E.OLT" alarm code (stopped by stall prevention) is displayed and operation
stopped.
(Alarm stop display "E.OLT")
2: If the load is heavy, the lift is predetermined, or the acceleration/deceleration
time is short, the stall prevention may be activated and the motor not
stopped in the preset acceleration/deceleration time. Therefore, set optimum
values to the Pr. 156 and stall prevention operation level.
CAUTION
Always perform test operation.
Stall prevention operation performed during acceleration may increase
the acceleration time.
Stall prevention operation performed during constant speed may cause
sudden speed changes.
Stall prevention operation performed during deceleration may increase
the deceleration time, increasing the deceleration distance.