Mitsubishi FR-E520-0.1KN - Confirmation of the Operation Mode

50
3.1.5 Confirmation of the operation mode
There are the "PU operation mode" and "CC-Link operation mode".
Use Pr. 79 "operation mode selection" to select between these operation modes.
Before changing from one operation mode to the other, confirm the following:
1) The inverter is at a stop;
2) Both the forward and reverse rotation signals are off; and
3) The Pr. 79 "operation mode" setting is correct.
Pr. 79 Setting Description
0
The parameter unit (FR-PU04) can be used to change between the PU
operation mode and CC-Link operation mode.
The CC-Link operation mode is selected at power-on reset.
1 PU operation mode (operation using the parameter unit (FR-PU04)).
2
(Factory setting)
CC-Link operation mode.
3