13-18 Useful advice for emergencies
• Headlamp installation
1. Insert the tabs on the headlamp into the
holes , and fit the headlamp in place.
2. Fit the headlamp’s bolts and connectors .
3. Pull out the screw in the vehicle.
4. Insert the stud pin on the dummy lamp into
the grommet hole , fit the dummy lamp in
place, and tighten the bottom screw .
CAUTION
Do not tighten the screw too tightly or the
mounting could get damaged.
5. Install the connector on the front and side turn
signal lamp .
6. Pull out screws .
7. Align the tabs with the holes , then press
the lamp in toward the centerline of the vehicle.
Z11272
Z11625
Z11273
Z11274
FEFG.book Page 18 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
