Mitsubishi MELSEC-F FX-1GM - Page 137

Responses of Each Signal
The responses
of each signal of an FX-1GM are described using the programming example given
below.
(Programming example:)
0 BLK K 0
I
Parameters
I No. 4 Max. speed: 500 PPS
1 ADR K 10 10 pulses are output.
I
No. 5 Bias speed: 500 PPS
Waits for an M-code OFF
signal from the program-
mable controller. The SV END signal is always kept ON.
Others
Used in combination with a programmable controller.
M-code OFF
Inputfilter BLK PDR DRV Pukeoutput WAlr Mi command wait DRV PuhOutpUt END
hr Ilmrlm
1m
1 ms
20 mr
1 mr
20 ms 1 ms
<
~
~ -
-
-- -
START command (START)
...
...
Pulse output (FP)
-Inputfilter
+I msec o( mwe
(bdh ON and OFF)
12 010
12 910
r=
n
r
Pulse output (FP)-code ON (on PGU)
(BFM #3b7)
M-code OFF (on PC)
ct<2 -
(BFM #1 b5)
Command is given from the PC after the
aux. device operation
is completed.
READY (Y6) I t+&&* PC's operation cycle
1 I r
I I I I
input Filter Times
PGO
0.5 msec DOG
1 ws
I Other than the above 1 3 msec I
- 135-