Mitsubishi MELSEC-F FX-1GM - Page 67

Putting theory aside
The fastest way to understand program creation is to learn by programming and monitoring simple
examples.
This section not only shows just how to create a program, but also shows how to check for troubles
by using the equipment listed below.
Since the drive unit and motor are not used, always be sure to check the current position by using
the monitor display of the TP when a simulation is in progress.
Items to prepare
Items related to the programmable controller
(1) FX-20P programming panel ............................................................................................... 1
(2) FX-32MR programmable controller ................................................................................... 1
(3) FX-32SW simulation input switch
..................................................................................... 1
items related to the PGU
(1) FX-1GM PGU ....................................................................................................................... 1
(2) F2-30TP TP ........................................................................................................................... 1
(3) F2-30GM-SIM simulation kit ............................................................................................... 1
(4) FX-1 GM-SIM-CAB cable ............................................................................................... 1 set
For application examples 1 and 2, it is not necessary to prepare the programmable controller
or its related parts. -
-65-