EasyManua.ls Logo

Mitsubishi Outlander PHEV 2019

Mitsubishi Outlander PHEV 2019
602 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
l
Automatic High-Beam (AHB)
CAUTION
l
To maintain proper performance of the
FCM, LDW and AHB;
Always keep clean the windscreen.
If the inside of the windscreen where the
sensor is installed becomes dirty or fog-
ged, contact a MITSUBISHI MOTORS
Authorized Service Point.
Do not apply an impact or load on the
sensor or its surrounding area.
CAUTION
Do not put anything including a sticker or
film to the outer side of the windscreen in
front of or surrounding area of the sensor.
Also, do not put anything including a
sticker or film on the both inner and outer
side of the windscreen under the sensor.
Do not attempt to detach or disassemble
the sensor.
If the windscreen is misted, remove the
mist from the windscreen by using the de-
mister switch.
Maintain the wiper blades in good condi-
tion.
Refer to “Wiper blades” on page 10-06.
When replacing the wiper blades, use on-
ly MITSUBISHI MOTORS GENUINE
parts or equivalent.
Do not dirty or damage the sensor.
Do not spray glass cleaner on the sensor.
Also, do not spill liquid, such as a bever-
age, on the sensor.
Do not install an electronic device, such
as an antenna, or a device that emits
strong electric waves near the sensor.
CAUTION
Always use tyres of the same size, same
type and same brand and that have no sig-
nificant wear differences.
Do not modify the vehicle’s suspensions.
l
If the windscreen on the sensor or in the sur-
rounding area of the sensor is cracked or
scratched, the sensor may not detect an ob-
ject properly. This could cause a serious ac-
cident. Turn off the FCM and have your ve-
hicle inspected as soon as possible at a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
If you need to replace the windscreen, con-
tact a MITSUBISHI MOTORS Authorized
Service Point.
l
The sensor emits infrared rays when the op-
eration mode is in ON. Do not look into the
sensor by using optical goods such as a mag-
nifying glass. The infrared ray might injure
your eyes.
Laser radar specifications
Laser classification
Max average power 45 mW
Pulse duration 33 ns
Wavelength 905 nm
Divergent angle (ho-
rizon x vertical)
28° x 12°
Forward Collision Mitigation System (FCM)*
7-75
OGGE19E1
Starting and driving
7

Table of Contents

Other manuals for Mitsubishi Outlander PHEV 2019

Related product manuals