If the system becomes temporarily unavaila-
ble due to a high or low temperature of the
sensor, the following warning message will
appear.
The indicator will appear on the informa-
tion screen of the multi-information display
and the FCM will automatically be turned
off. After the temperature of the sensor has
been in range, the system will automatically
return to operation.
If the display keeps showing the message,
there is a possibility that the FCM has a mal-
function. Contact a MITSUBISHI MOTORS
Authorized Service Point for inspection of
the system.
If the FCM detects a malfunction in the sys-
tem, either one of the following messages
will appear, the indicator will appear on
the information screen of the multi-informa-
tion display and the FCM will automatically
be turned off.
If the message remains even after the opera-
tion mode is put in OFF and then turned back
to ON, please contact a MITSUBISHI
MOTORS Authorized Service Point.
NOTE
l
If the sensor or its surrounding area reaches
an extremely high temperature when parking
the vehicle under a blazing sun, the “FCM
SERVICE REQUIRED” message may ap-
pear.
After the temperature of the sensor or its sur-
rounding area has been in range, if the mes-
sage remains even after restarting the en-
gine, please contact a MITSUBISHI
MOTORS Authorized Service Point.
Handling of the sensor
E00652200125
The sensor (A) is located inside the wind-
screen as shown in the illustration.
The sensor is shared in the following sys-
tems:
l
FCM
l
Lane Departure Warning (LDW)
Forward Collision Mitigation System (FCM)*
7-74
OGGE19E1
Starting and driving
7
To Next Page
Loading...
