Perform this operation when you want to register the LOSSNAY, confirm the registered units,
or delete the registered units controlled by the remote controller.
The following uses indoor unit address 05 and LOSSNAY address 30 as an example to describe
the setting procedure.
[Setting Procedure]
Stop the air conditioner using the remote controller button.
Press and hold down the and buttons at the same time for two seconds. The
display shown below appears. The remote controller confirms the registered LOSSNAY
addresses of the currently connected indoor units.
Registration confirmation result
- The indoor unit address and registered LOSSNAY address are displayed alternately.
Make this setting only when interlocked operation with LOSSNAY is necessary with
CITY MULTI models.
ON
OFF
.
<Indoor unit address and indoor unit display>
<LOSSNAY address display and LOSSNAY display>
1
2
3
- When LOSSNAY is not registered.
If registration is unnecessary, end registration by pressing and holding down the and
buttons at the same time for two seconds.
If a new LOSSNAY must be registered, go to step 1. Registration procedure.
If you want to confirm another LOSSNAY, go to step 2. Confirmation procedure.
To delete a registered LOSSNAY, go to step 3. Deletion procedure.
.
4
To Next Page
Loading...
