[6-6 Changing the Room Temperature Detection Position ]
- 117 -
HWE12050 GB
6 Test Run
6-6 Changing the Room Temperature Detection Position
1. Selecting the position of temperature detection (Factory setting: SW1-1 on the controller board on the indoor unit is
set to OFF.)
To use the built-in sensor on the remote controller, set the SW1-1 on the controller board on the indoor unit to ON.
Some models of remote controllers are not equipped with a built-in temperature sensor. Use the built-in temperature sensor
on the indoor unit instead.
When using the built-in sensor on the remote controller, install the remote controller where room temperature can be detected.
To Next Page
Loading...
