3.3.2 Floppy Disk Drive
Use the supplied connection cable to connect the floppy disk drive (FDD) with the FD
connector on the rear of the data processing unit.
The floppy disk drive is used to store and retrieve the part programs or measured data
on the floppy disk.
Connection cable
Eject button
Access LED
Fig. 3-2
IMPORTANT
• Make sure to turn off the power switch on the data processing unit before connecting the
floppy disk drive and the data processing unit.
• For the floppy disk drive, use a 3.5” floppy disk (2HD, 1.44 MB) that has been formatted
for MS-DOS.
• Do not use a cleaning disk in the floppy disk drive.
• When the access LED on the front of the floppy disk drive is lit, do not use the eject button
or connect or disconnect the connection cable.
No. 99MCA081A
3-4
To Next Page
Loading...
