4. MAINTENANCE AND TROUBLESHOOTING
(10) It is not possible to write or read data using a floppy disk.
Point to check Cause and remedy
Is the floppy disk set to write-protect?
Shift the write-protect tab on the floppy disk to the
write-enable position.
Is the floppy disk inserted correctly? Insert the floppy disk correctly, then try again.
Are the connectors in the connection cable between
the floppy disk drive and the data processing unit
“QM-Data” securely connected?
Confirm the connection of the connectors in the
connection cable.
Is the floppy disk formatted properly?
Reformat the floppy disk using your personal
computer (1.44 MB; 2HD).
Is the floppy disk formatted?
Format the floppy disk using your personal computer
(1.44 MB; 2HD).
The contents of the floppy disk might be damaged.
The damaged contents cannot be recovered. If there
is a backup floppy disk, use it.
(11) Data cannot be input using the touch signal probe.
Point to check Cause and remedy
Is the touch signal probe’s cable connection OK?
Check the connection between the touch signal
probe's cable and the main unit of the CMM
(Coordinate Measuring Machine).
(12) Data cannot be input by stepping on the foot switch.
Point to check Cause and remedy
Is the foot switch cable connection OK?
Check the connection between the foot switch cable
and the data processing unit “QM-Data” .
No. 99MCA081A
4-5
To Next Page
Loading...
