Mobotix D15 - Page 4

4/112
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
D15 Camera Manual
2.2 Network Connections Overview 44
2.2.1 Power-Over-Ethernet (PoE Conforming to IEEE 802.3af) 44
2.2.2 Uninterruptible Power Supplies (UPS) 45
2.2.3 Preparing the Camera Connections, Wall Outlets 45
2.2.4 Wiring, Fire Prevention, Lightning and Surge Protection 46
2.3 First Installation Steps 48
2.3.1 Mounting Lens Units 48
2.3.2 Overview of Cable Connections 52
2.3.3 Connecting the Ethernet Cable with the MX-Overvoltage-Protection-Box 53
2.3.4 Connecting the MiniUSB Cable 53
2.3.5 Connecting MxBus Modules 55
2.3.6 Replacing the MicroSD Card 56
2.4 Mounting the Camera with Outdoor Wall Mount 58
2.4.1 Aiming the Passive Infrared Sensor (PIR) 58
2.4.2 Mounting the Outdoor Wall Mount 59
2.4.3 Aiming the Camera 61
2.4.4 Connecting the Camera with Bottom Plate 62
2.4.5 Connecting And Securing The Camera 63
2.5 Mounting the Corner and Pole Mount 64
2.5.1 Overview 64
2.5.2 Mounting to the Corner of a Building 65
2.5.3 Mounting to a Pole 66
2.5.4 Mounting the Outdoor Wall Mount 67
2.6 Adjusting the Lens 68
2.7 Network and Power Connection 69
2.7.1 Notes on Cable Lengths and Power Supply 69
2.7.2 Power Supply with Power-Over-Ethernet Products 69
2.7.3 Power Supply Using a Switch 70
2.7.4 Power Supply When Connected Directly to a Computer 71
2.7.5 Variable PoE 72
2.7.6 Camera Startup Sequence 73
3 Operating the Camera 74
3.1 Manual and Automatic Operation – Overview 74
3.2 First Images and the Most Important Settings 76
3.2.1 Manually Setting Up the Network Parameters in a Browser 76
3.2.2 First Images and the Most Important Settings in the Browser 79
3.2.3 First Images and Network Parameter Configuration in MxMC 81
3.2.4 Starting the Camera with Factory (Network) Settings 84
3.2.5 Starting the Camera with an Automatic IP Address (DHCP) 85
3.3 Virtual PTZ and Full Image Recording 86
3.3.1 Virtual PTZ 86
3.3.2 Full Image Recording 88