Mobotix D15 - Power Supply Using a Switch

70/112
D15 Camera Manual: Mounting
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
2.7.3 Power Supply Using a Switch
1. Connect the factory pre-installed cable of the camera to the camera connector of
the PoE adapter.
2. Connect the LAN/Power connector of the PoE adapter to the Ethernet connector
of the switch/router or the Ethernet socket.
3. Plug the RJ45 connector of the power supply unit into the PC/Power connector
of the PoE adapter.
The IP addresses in
the diagram are shown
only as an example
Switch/router
PoE adapter
(MX-NPA-PoE)
Power supply unit
LAN/www
PC (10.8.0.11/255.0.0.0) Camera (10.8.0.99)
LAN/Power
PC/Power
Camera
RJ45
RJ45
RJ45
For the D15 you should
use the blue MX-NPA-
PoE-Set or the MX-NPA-
Box – previous MOBOTIX
network power acces-
sories, such as the
NPA-Set, Power-Box and
Power-Rack (MX-NPA-
Set, MX-NPR-4 and
MX-NPR8/20) are
not suitable for use
with the D15.