2.2 Reset to factory settings
By pressing the reset-button for a long time, the MC can be set back to its factory settings. When keeping the
reset button pressed, the MC goes through different sequences that are visualized by all four LEDs lighting
up in the same color.
The LED-sequences start with lighting up in white, then blue, then red and then green; restarting with white
again. Holding the reset button pressed after the third time the all LEDs light up blue, the device is set back
to its factory settings. All LEDs are off during the reset to factory settings. After that, the reset button can be
released. When the reset button is released before the factory reset was initiated, then the MC needs to be
restarted by briefly pressing the reset button again.
The MC posses the following (important) factory settings:
Device Name: „MC“
SSID = „MC_WLAN“
Encryption mode = no encryption
MODE= 802.11 a/b/g/n (2.4 + 5 GHz)
IP = 192.168.170.100
Netmask = „255.255.255.0“
Gateway = 192.168.170.249
user = „“ (empty)
password = „“ (empty)
Serial 1: inactive
Relay: inactive
Input: inactive
MC Manual Version 2.10c
To Next Page
Loading...
