3. Getting Started
Table 3.4 (Continued) MENU Button and Menus
Menu Selection Purpose/Action
▷ ▷ DC Shutdown Sets the inactivity timeout for shutdown while the
device is running on external DC supply.
▷ ▷ Battery Power Save Sets the inactivity timeout for power save mode while
the device is running on battery.
▷ ▷ Battery Shutdown Sets the inactivity timeout for shutdown while the
device is running on battery.
▷ ▷ Battery Icon Toggles battery icon display on/off.
▷ ▷ Power Display Toggles the on-screen power status display on/off.
▷ Diagnostics
▷ ▷ Analog Runs automated diagnostics on the analog trace
acquisition circuit board. Results are displayed
on-screen in a message box.
▷ ▷ Database Clean Database: CAUTION! Not for routine use.
This option defragments the database, freeing up
unused space, then turns off the CT100B. Use this
option only when the CT100B is plugged into an
external power supply. Do not shutdown the CT100B
while the Clean Database command is in progress.
▷ ▷ Front Panel Check Opens the front panel button and knob check screen.
Hit each button once and turn every knob in each
direction. Press the red POWER button to exit when
finished.
▷ ▷ Jitter Jitter measures signal noise, jitter, rise time, and
sampling efficiency of the trace. These values are used
as part of the calibration checkout for the CT100B,
and results of interest are explained in Appendix B:
Operator Performance Checks.
▷ Info
▷ ▷ License
▷ ▷ ▷ License Info Gives information about the license installed on the
CT100B.
▷ ▷ ▷ License from USB Use this option to load a license code from a USB
flash drive.
▷ ▷ ▷ Enter License Manually load a license code. This is useful for
operators who are unable to connect to CT Viewer 2
or use a flash drive.
28 CT100B TDR Cable Analyzers Operator’s Manual
To Next Page
Loading...