Mohr CT100B Series - Use Set Start Point to Annotate a Specific Point on a Trace; Use Set Start Point and Set End Point to Annotate a Range of Points on a Trace

4. Operating Instructions
Figure 4.25. Use Set Start Point to annotate a specific point on a trace.
Figure 4.26. Use Set Start Point and Set End Point to annotate a range of points on a
trace.
To view a list of all annotations attached to a trace, go to SCAN → Annotations → List
Annotations. A scrolling dialog appears that lists the annotation text and any start and end
points. See Figure 4.27.
58 CT100B TDR Cable Analyzers Operator’s Manual