molex BradControl HarshIO 600 eIP - Page 19

HarshIO 600 eIP

19

IP67 Digital I/O Modules for EtherNet/IP
Type
12x INPUTS + 4x OUTPUTS
8x INPUTS + 8x OUTPUTS
Product Reference
TCDEI-8B4P-DYU-G (4-pin power version)
TCDEI-8B4P-D1U-G (5-pin power version)
TCDEI-888P-DYU-G (4-pin power version)
TCDEI-888P-D1U-G (5-pin power version)
Power
Power IN connector
Mini Change (7/8”), 4-pin or 5-pin, male, stainless steel, Maximum 8 A
Power OUT connector
Mini Change (7/8”), 4-pin or 5-pin, female, stainless steel, Maximum 8 A
Module & Input power (UB)
24 VDC, -15/+20% (protected against power crossing)
Warning, a voltage over 30 VDC will destroy the module
Operating current (UB)
68 mA
Output power (UL)
24 VDC, -15/+20% (protected against power crossing)
Operating current (UL)
10 mA (without load)
Inputs
Channels
12 channels, 2 or 3-wire
8 channels, 2 or 3-wire
Connector
M12 Ultra-Lock, 5-pin, female, A-Coded, stainless steel
Input type
PNP, Sinking
Input voltage
UB
Sensor power supply
140 mA at 25°C
Input channel voltage (“1”)
10V … 30V
Input channel voltage (“0”)
-0.2V … 5V
Input short circuit
protection (per port)
600mA
Input filter
1 … 5 ms (5 ms by default)
Outputs
Channels
4 channels, 2-wire
8 channels, 2-wire
Output voltage
UL -1 VDC
Connector
M12 Ultra-Lock, 5-pin, female, A-Coded, stainless steel
Output type
PNP, Sourcing
Output current
2 A per channel
Maximum output current
8.0 A at 25°C ; total for all outputs combined
Short circuit current (typical)
up to 6.5 A
Switching frequency
200 Hz