26
DOOR PROTECTORS
Check door protectors are clean and in good condition, replace if necessary.
Door Protector Replacement
1. To remove door protectors, push tube vertically upwards and pivot bottom of tube away from
carriage so tube is at approximately 30 degrees from carriage, then pull the tube down and away
from the top door protector retaining bracket.
2. Slide the internal steel tubing out of the old door protector foam and slide steel tubing inside new
door protector foam.
3. To refit door protectors, reverse step 2.
MAJOR INSPECTION
In addition to regular maintenance, Major Inspections are required at a minimum of 10 year intervals (or
equivalent based on usage or environment) to assess suitability for continuation of operation.
To Next Page
Loading...