6
SAFETY PRECAUTIONS
For your own safety and the safety of equipment, always take the following precautions
Failure to comply with these precautions may result in loss of load, damage to unit and/or personal injury
Servicing a Hoist must be
performed and recorded
by a competent person.
Ensure you are
authorised to service a
hoist and that you are
familiar with all aspects of
the hoist.
Cordon off work area
using safety cones or
other safety barricade.
Ensure area is clear of
any obstruction prior to
servicing.
Do not conduct
maintenance with vehicle
on hoist.
Do not try to adjust relief
valve as it has been set
at maximum operating
efficiency.
This vehicle hoist is not
designed to be used in &
around steam cleaning
nor be installed in the
open, exposed to the
elements. Hoist operated
in such conditions are not
covered by our warranty.
Do not force safety
release lever into the off
position while weight is
resting on the carriage
safety locks.
In moist conditions,
ensure moving
components are well
lubricated.
Seal and protect all
electrical components
from elements.
Clean the hoist with
warm water and non-
abrasive pH neutral
detergents. Surfaces
should be thoroughly
rinsed to remove residue.
Do not oil or grease the
lifting arm assemblies.
Do not make any
changes to safety
equipment.
Use only recommended
wire rope lubricants
Isolate hoist from power
to protect from
unintended movement
when working on internal
components, balance
cables and power
system.
To Next Page
Loading...
