27
Communicator Test
Your system must be monitored by a Central Station
to perform this test. This test will take a while to
perform.
This test is used to verify that your system is communicating with the
Central Station.
To perform a communicator test:
1. Press . The Control Station will display:
2. Enter passcode: .
The Control Station will display:
3. Press . The Control Station will display:
4. If the test passes, the Control Station will sound four (4) beeps
when the test is completed. The Control Station will display:
If the test fails, a Communications Failure trouble condition results
several minutes later. The Control Station will display:
TESTING YOUR SYSTEM
8
NOTE
4
To Next Page
Loading...
