30
Remote Connect
Contact your Security Company Representative for instructions.
Programming the User Passcodes
Your system may be programmed with up to 9 user passcodes. Consult
your Security Company Representative as to which passcodes have
been enabled and what Authority Level has been assigned to each one.
To program User Passcodes:
1. Press . The Control Station will display:
2. Enter passcode: .
The Control Station will display:
ZX200/ZX210 Programming
Your system has several features which you may be able to program
yourself. DO NOT attempt to program the system unless you have
been properly trained on programming procedures and you fully
understand these operations. There are two (2) options available:
ZX200/ZX210 PROGRAMMING
1 Remote Connect Allows the installer to program and diagnose
problems from a remote site using the
telephone lines.
2 Program User Codes Allows you to change any passcodes.
9
To Next Page
Loading...
