Morbark BEEVER M12RX - Safety Checklist

1.6
qFuel and oil line connections are securely attached to the fittings and
there is no sign of fluid leakage. Tubes and hoses are in good condition
qFiller caps and drain plugs are securely attached to the machine
qHood latches and pins are in place
qComponents, parts, and hinges are not broken or cracked
qHardware (e.g., bolts, nuts, pins) are in place and tightened
qAll tires are properly inflated according to the manufacturer’s
specifications
qAll safety decals are clean and legible. If not, replace all missing or
damaged labels
qThe product manuals are in good shape and in the manual holder
Work Site
qThere are at least two trained operators at the work site. Never leave one
person at the work site alone
qForeign objects are removed from the work area
qThe machine is set up in a safe environment (e.g.: no power lines) and in
an area that is well lit and ventilated
qAll spectators are at a safe distance from the machine and the work area
is marked off with safety pylons or rope
Set Up
qThe machine is set up on a flat and stable ground or surface
qIf the chipper is attached to a truck or van, the hitch is secure, the safety
chains are properly attached, the brake is on, and no one is in the vehicle
qIf the chipper is not attached to a vehicle, ensure chocks are placed under
the wheels
Be sure to check that you have the following items at the beginning of
each session or when changing operators:
qEmergency equipment on work site:
• communication device
• stocked first aid kit
• approved, charged fire extinguisher, is at the work site
qPersonal clothing and protective gear
• hard hat
• safety goggles
• ear protection
• hard toe work boots with non-skid soles
• gloves without cuffs (note: Never wear gauntlet style gloves due to
the possibility of snagging)
• shirt is close fitting and tucked in
• pants without cuffs
• long hair is contained in a hair net or wrapped underneath
the hard hat
Daily Maintenance
q All recommended grease points are greased (see Maintenance section)
q Hydraulic oil, engine oil, and fuel and radiator coolant is at their proper
levels and clean
Machine Inspection
q Machine is clean and debris is removed from around the engine, muffler,
chipper housing, infeed, and discharge chutes
q All safety devices and controls (e.g.: safety cables) are in good condition
and operating properly
qShields and guards are in place and in good condition
qBattery cables, electrical wiring, and connections are in good shape and
do not have cracks
Safety Checklist
76347-385 • 06-15
Safety • Start-up Checklist