76347-385 • 06-15
2.1
Section 2
The Chipping Cycle
Preparation
Preparation and Set-up ...................................2.2
Start-up
Fluid Levels .............................................2.6
Engine Start-up..........................................2.6
After Engine Warm-up Conventional Clutch....................2.7
Chipping the Wood
Feeding Brush into the Chipper .............................2.8
Shut-down
Machine Shut-down ......................................2.9
Lock-up................................................2.9
Clean-up...............................................2.9
Checklist
Start-up ...............................................2.10
Shut-down .............................................2.10
To Next Page
Loading...