24
8. CARE AND MAINTENANCE
8.1 Do not disassemble
Disassembly may significantly effect the performance of the instrument, and may result in electric
shock or injury and will void the terms of the warranty.
Never attempt to dismantle any parts other than described in this manual. If you notice any
malfunction, contact your nearest Motic representative.
8.2 Cleaning the microscope
8.2.1 Lenses and filters
To clean lens surfaces or filters, first remove dust using an air blower. If dust still persists, use a
soft / clean brush or gauze.
A soft gauze or lens tissue lightly moistened with the mixture of alcohol and ether
( ratio : alcohol : 3 and ether: 7) should be used to remove grease or fingerprints.
Use only a mixture of alcohol and ether ( ratio : alcohol : 3 and ether: 7) to remove immersion oil
from objective lenses.
Because the mixture of alcohol and ether ( ratio : alcohol : 3 and ether: 7) is highly flammable, be
careful handling around open flame.
Do not use same area of gauze or lens tissue to wipe more than once.
8.2.2 Cleaning of painted or plastic components
Do not use organic solvents (thinners, alcohol, ether, etc.). Doing so could result in discolouration or
in the peeling of paint.
For stubborn dirt, moisten a piece of gauze with diluted detergent and wipe clean.
For plastic components, only moisten a piece of gauze with water and wipe clean.
8.3 Disinfecting the Microscope
Follow the standard procedures for your laboratory.
8.4 When not in use
When not in use, cover the instrument with vinyl dust cover and store in a place low in humidity
where mould is not likely to form.
Store the objectives, eyepieces and filters in a container or desiccator with drying agent.
Proper handling of the microscope will ensure years of trouble free service.
If repair becomes necessary, please contact your Motic agency or our Technical Service direct.
To Next Page
Loading...
