6809490A77-O October 4, 2004 29
Level 1 and 2 Service Manual Disassembly
8. Using the disassembly tool, disengage the joystick flex from its connector.
To Replace the Joystick Assembly
1. Align the joystick flex with its connector and press it into place.
2. Align the 2 joystick locking tabs with the transceiver board and snap it into
place.
3. Replace the transceiver board, rear housing, USIM, battery, and battery door
as described in the procedures.
Figure 15. Removing and Replacing the Joystick Assembly
Joystick
Flex
Disassembly
Tool
To Next Page
Loading...
