Motorola A1000 - Removing and Replacing the Display Assembly

30 October 4, 2004 6809490A77-O
Disassembly A1000
Removing and Replacing the Display Assembly
To remove the Display Assembly
1. Follow the procedures to remove the:
•Battery Door
•Battery
•USIM Card
• Rear Housing
• Transceiver board
• Joystick Assembly
2. Using the disassembly tool, disengage the display flex from its connector.
3. Release the display assembly clips from the transceiver on each side of the
display assembly as shown in Figure 16.
4. Carefully disengage the 2 display locking tabs (1 one each side of the display).
5. Carefully lift the display assembly away from the transceiver board.
G
The flexible printed cable connecting the display module to the display board is
fragile. Use extreme care when handling.
Figure 16. Removing the Display Flex Connector
Disassembly
Tool
Display Flex
Connector