Motorola A1000 - Removing and Replacing the MFT Assembly

32 October 4, 2004 6809490A77-O
Disassembly A1000
Removing and Replacing the MFT Assembly
To Remove the MFT Assembly
1. Follow the procedures to remove the:
•Battery door
•Battery
•USIM Card
• Rear Housing
• Transceiver Board
• Joystick Assembly
• Display Assembly
2. Disengage the 2 MFT assembly locking tabs.
3. Lift the MFT assembly away from the transceiver board.
To Replace the MFT Assembly
1. Align the MFT assembly over the transceiver board and snap the locking tabs
in place.
2. Replace the display assembly, joystick assembly, transceiver board, rear hous-
ing, USIM, battery, and battery door as described in the procedures.
Figure 18. MFT Assembly Removal
MFT Assembly
Locking Tab
MFT Assembly
Locking Tab