6809490A77-O October 4, 2004 23
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Transceiver Board
To Remove the Transceiver Board
1. Ensure the phone is off.
2. Remove the battery door.
3. Remove the battery.
4. Remove the USIM.
5. Remove the rear housing.
6. Remove the 2 T-6 screws with a T-6 Torx Plus bit at the top securing the
transceiver board to the front housing.
7. Partially lift the front housing off of the transceiver board.
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
Figure 9. Removing the Transceiver Board
Screw
Locations
To Next Page
Loading...
