Motorola APX 6000 Service Manual

4-6 Troubleshooting Procedures: Power-Up Self-Check Diagnostics and Repair (Not for Field Use)
Hardware board
mismatch
Expansion board does not support bluetooth feature. Send radio to depot.
If the Expansion board type supports “Full feature” – “Mace/GPS/BT/SDMem Exp
Board”, updating the expansion board firmware should resolve the error message.
Hardware board
mismatch
then
Man-Down HW error
Expansion board does not support either bluetooth or Man-down feature or both.
If the Expansion board type supports “Full feature” – “Mace/GPS/BT/SDMem Exp
Board”, updating the expansion board firmware should resolve the error message.
Table 4-5. Power-Up Self-Check Diagnostic Actions (Continued)
Error Code/ Error
Message
Diagnostic Actions

Motorola APX 6000 Specifications

General

Frequency Range	700/800 MHz, VHF, UHF Range 1, UHF Range 2
IP Rating	IP67
P25 Phase 1 & 2	Yes
GPS	Yes
Encryption	AES, DES
Power Output	1-3 Watts (700/800 MHz)
Operating Temperature	-30°C to +60°C
Intrinsically Safe	Yes
Bluetooth	Yes (Bluetooth 4.0)