General Radio Operation
17
• Changing (Reprogramming) a List
• Only numbers can be changed (reprogrammed) in a list. To change
the names in a list, a qualified service center must reprogram your
radio using radio service software. A name can be a maximum of 14
characters.
• If you are using the scan feature, refer to page 46 for scan-list
reprogramming.
1. Press until the softkey appears on the
display. (The exact location of softkeys will vary
based upon individual radio programming.)
2. Press directly below .
3. The display changes to show the lists ( ,
, , etc.) that can be changed.
4. Press directly below the list you wish to
change. For example, to change a telephone
number, press directly below .
5. The display will show the first member in the list (name on the upper
line, number on the lower line). The status indicator will appear
(flashing), indicating you are in the programming mode.
Notes
HOME
HOME
Flashing = Programming Mode
First Member in the List
General Radio Operation Page 17 Wednesday, April 10, 1996 12:19 PM
To Next Page
Loading...
Need help?
General
